Msd 8565 Marine HEI Tower Cap w_Wire Retainer Installa User Manual download pdf

M S D I G N I T I O N • w w w. m sd ig ni ti on .c om • ( 91 5) 8 5 7- 52 00 • F A X (9 15 ) 85 7- 33 4 4

MSD Marine Distributor Cap

PN 8565

Parts Included:

1 - Cap, PN 8565

2 - 10-32 x 3/4" SHC Screws

Note: If you need to adapt your spark plug wire boots and terminals to ﬁt the towers of the PN 8565

Cap, MSD offers a kit of nine boots and terminals, PN 8849.

This Cap ﬁts MSD Marine Distributors that may also use the Socket style MSD Cap, PN 8564.

Before installing the new cap, note the location of the spark plug wires. It is a good idea to mark the

location of one wire before removing it while leaving the other wires connected to the old cap. Install

the new cap by using the two 10-32 x 3/4" socket head cap screws. With the new cap installed, you

can install each wire individually avoiding any confusion.

After installing the spark plug wires, position the retainer over the boots. Align the mounting bosses and

use the supplied 1.5" self-tapping Phillips head screws to hold the retainer in place. It may be necessary

to apply a slight amount of lubricant to the boots to help them seat into the retainer properly.

1 - Wire Retainer

2 - 1.5" Phillips Head Screws

Figure 1 Installing the Wire Retainer.

1 2

M S D I G N I T I O N • w w w. m sd ig ni ti on .c om • ( 91 5) 8 5 7- 52 00 • F A X (9 15 ) 85 7- 33 4 4MSD Marine Distributor Cap

2 INSTALLATION INSTRUCTIONS Limited Warranty MSD IGNITION warrants this product to be free from defects in material and workmanship under its intend

No comments

Msd 8565 Marine HEI Tower Cap w_Wire Retainer Installa User Manual