Msd 8207 Blaster SS Coil Installation User Manual download pdf

IMPORTANT: Read instructions before attempting the installation.

Parts Included:

1 - Blaster SS Coil, PN 8207

3 - Vibration Mounts and Hardware

2 - Male Faston Connectors

WARNING: During installation, disconnect the battery cables. When disconnecting the battery,

always remove the Negative cable ﬁrst and install it last.

Note: If installing the Blaster SS Coil to a points distributor or a non-current limiting ignition system without

an MSD Ignition, a 0.8 ohm ballast resistor is required (MSD PN 8214). The resistor should wire in

series along with any factory resistors on the

positive coil wire.

1. Find a suitable mounting location for the coil.

It can be mounted in any position as long as it

is away from direct engine heat sources.

2. Use the coil as a template and mark the

mounting holes using a punch.

3. Using a 3/16” drill bit, drill the three holes to

mount the coil.

4. Install the vibration mounts and mount the coil.

5. Install the Faston connectors to the coil

terminals. Connect the coil wires from the MSD

or stock ignition and the secondary coil wire.

MSD 6 or 7 Series Ignition Control

The Orange wire connects to the coil positive

terminal and the Black connects to the coil negative

terminal. These are the only two wires that connect

to the coil terminals.

MSD 5 or Blaster Ignition

The Red wire connects to coil positive and the

Orange connects to coil negative.

1 - 90° MSD Spark Plug Boot

1 - 90° Dual Crimp Terminal

WARNING: The Blaster SS and MSD Ignition Controls produce very high voltages. Never short the battery

or coil terminals. Use caution during installation and while working near the ignition or coil.

Figure 1 Mounting Template.

MSD Blaster SS Coil

PN 8207

ONLINE PRODUCT REGISTRATION: Register your MSD product online and you’ll be entered

in our monthly 8.5mm Super Conductor Spark Plug Wire give-away! Registering your product

will help if there is ever a warranty issue with your product and helps the MSD R&D team create

new products that you ask for! Go to www.msdperformance.com/registration.

M S D • W W W . M S D P E R F O R M A N C E . C O M • ( 9 1 5 ) 8 5 7 - 5 2 0 0 • F A X ( 9 1 5 ) 8 5 7 - 3 3 4 4

1 2

MSD Blaster SS Coil 1
CRIMPING 2

Summary of Contents

Page 1 - MSD Blaster SS Coil

IMPORTANT: Read instructions before attempting the installation.Parts Included:1 - Blaster SS Coil, PN 82073 - Vibration Mounts and Hardware2 - Male F

Page 2 - CRIMPING

Limited Warranty MSD warrants this product to be free from defects in material and workmanship under its intended normal use*, when properly installe

Comments to this Manuals

No comments

Msd 8207 Blaster SS Coil Installation User Manual

Browse online or download User Manual for For the car Msd 8207 Blaster SS Coil Installation. MSD 8207 Blaster SS Coil Installation User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for For the car Msd 8207 Blaster SS Coil Installation