Msd 8830 Noise Capacitor, 26 Kufd Installation User Manual download pdf

Figure 1 Installing the Noise Filter Capacitor.

Parts Included:

1 – Noise Filter Capacitor

1 – Mounting Bracket

2 - #10 Cup Washers

2 – 10-32 x 3/8” Screws

4 – Star Washers

1 – Cover

1. For best results, it is recommended to mount the Capacitor as close as possible to the MSD Ignition

Control. Find a secure mounting point and mark the location of the mounting holes. Use a 3/16”

bit to drill the holes and use the supplied screws to mount the Capacitor.

2. Mark the point where the MSD’s heavy Red and Black wires will be connected to the Capacitor

terminals (note that there is a positive (+) and a negative (-) terminal. Strip about 1¼” of insulation

from the wire at this point (Ringlug terminals can also be used).

3. Form a loop at the stripped wiring point and attach the Red to the positive terminal and the Black

wire to the negative terminal with the supplied hardware as shown in Figure below.

IDENTIFYING AND PREVENTING RADIO NOISE

Radio noise can be frustrating but there are steps you can take to isolate the problem. If the noise

disappears when the MSD is bypassed, then the ignition has added a factor that directly, or indirectly

causes the interference.

Due to the increased output of the MSD, the breakdown of items like the spark plug wires, spark

plugs or related components may be brought into the light so the ignition components should be

inspected. Also check the following:

MSD Noise Filter Capacitor

PN 8830

M S D • W W W . M S D P E R F O R M A N C E . C O M • ( 9 1 5 ) 8 5 7 - 5 2 0 0 • F A X ( 9 1 5 ) 8 5 7 - 3 3 4 4

ONLINE PRODUCT REGISTRATION: Register your MSD product online and you’ll be entered

in our monthly 8.5mm Super Conductor Spark Plug Wire give-away! Registering your product

will help if there is ever a warranty issue with your product and helps the MSD R&D team create

new products that you ask for! Go to www.msdperformance.com/registration.

1 2

MSD Noise Filter Capacitor 1

Summary of Contents

Page 1 - MSD Noise Filter Capacitor

Figure 1 Installing the Noise Filter Capacitor. Parts Included:1 – Noise Filter Capacitor1 – Mounting Bracket2 - #10 Cup Washers2 – 10-32 x 3/8” Scre

Page 2

• The chassis and engine must have a common ground. A ground strap from the frame to the engine is important. All radio, CD players, CB systems and ot

Comments to this Manuals

No comments

Msd 8830 Noise Capacitor, 26 Kufd Installation User Manual

Browse online or download User Manual for For the car Msd 8830 Noise Capacitor, 26 Kufd Installation. MSD 8830 Noise Capacitor, 26 Kufd Installation User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for For the car Msd 8830 Noise Capacitor, 26 Kufd Installation